What is a Basic Tune?
*The action and regulator are stripped, examined and cleaned
*Regulator is serviced and set to the correct pressure requirement
*Any loose or parts that do not fit properly are tightened and/or refinished correctly
*Burrs, dirt, some tool marks, etc are removed or repaired
*Any worn or damaged O rings are replaced and properly lubricated
*The standard metal spring guide is modified or replaced depending on power requirements
*A low friction disk/bearing is fitted to the hammer assembly
*The trigger sear pin and sear body is polished and lubricated to make it smoother to operate
*A new hammer spring maybe selected to enhance your rifle’s power requirements
*The ends of the hammer spring and firing valve spring are de-burred and polished
*The transfer port is modified to improve air flow, depending on your rifles power requirements
*The pellet inlet and magazine bridging part is modified to make it easier to load magazine and for smoother pellet transition from magazine to barrel
*Check the barrel is aligned correctly with the transfer port and make sure the barrel is secure
*Modify the port in the barrel to improve airflow
*Check the barrel crown and repair/re-crown if necessary
*Make sure the gun is in good working condition
*Set the power according to customer’s power requirements
*If you use the new style magazines I can remove the indexing parts to improve consistency
*Supply a Repair/Tune worksheet with a list of the work done
541-606-3413